Central Pneumatic 47016 67181 Manuel du propriétaire télécharger pdf (Page 6)

Page 6 For technical questions, please call 1-888-866-5797. Item 47016 67181

NOTICE

Clean the Spray Gun IMMEDIATELY after EVERY use.

Delayed or inadequate cleaning will permanently clog the Spray Gun.

Latex paint hardens quickly and permanently inside Spray Gun.

SAFETY OPERATION MAINTENANCESETUP

Initial Set Up

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual

including all text under subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following

pages, refer to the Assembly Diagram near the end of this manual.

Before Setup

1. This air tool may be shipped with a

protective plug covering the air inlet.

Remove this plug before set up.

2. Before first use, clean the Spray Gun using

a solvent-based thinner. If not removed,

the material used for testing and corrosion

prevention will contaminate paint.

Air Supply Setup

TO PREVENT SERIOUS INJURY FROM EXPLOSION:

Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen, carbon

dioxide, combustible gases,

or any other bottled gas as a power source for this tool.

1. Incorporate a filter, regulator with pressure gauge,

in-line shutoff valve, and quick coupler for best

service, as shown on Figure A on page 7 and

Figure B on page 8. An in-line shutoff ball

valve is an important safety device because

it controls the air supply even if the air hose

is ruptured. The shutoff valve should be a

ball valve because it can be closed quickly.

Note: Do not use an automatic oiler system or

add oil to airline. The oil will contaminate the

material being propelled, ruining the final result.

2. Attach an air hose to the compressor’s air outlet.

Connect the air hose to the air inlet of the tool.

Other components, such as a coupler plug

and quick coupler, will make operation

more efficient, but are not required.

WARNING! TO PREVENT SERIOUS INJURY

FROM ACCIDENTAL OPERATION:

Do not install a female quick coupler on the tool.

Such a coupler contains an air valve that will

allow the air tool to retain pressure and operate

accidentally after the air supply is disconnected.

Note: Air flow, and therefore tool performance,

can be hindered by undersized air supply components.

3. The air hose must be long enough to reach

the work area with enough extra length to

allow free movement while working.

4. Close the in-line shutoff valve between

the compressor and the tool.

5. Turn on the air compressor according to

the manufacturer’s directions and allow it

to build up pressure until it cycles off.

6. Adjust the air compressor’s output regulator

so that the air output is enough to properly

power the tool, but the output will not exceed

the tool’s maximum air pressure at any time.

Adjust the pressure gradually, while checking the

air output gauge to set the right pressure range.

7. Inspect the air connections for leaks.

Repair any leaks found.

8. If the tool will not be used at this time,

turn off and detach the air supply and

safely discharge any residual air pressure

to prevent accidental operation.

Note: Residual air pressure should not be present

after the tool is disconnected from the air supply.

However, it is a good safety measure to attempt to

discharge the tool in a safe fashion after disconnecting

to ensure that the tool is disconnected and unpowered.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Central Pneumatic 47016 67181 Manuel du propriétaire Page 6

Commentaires sur ces manuels